Математическое моделирование процесса изгибных колебаний стержня с промежуточной абсолютно жесткой массивной вставкой
Работая с сайтом, я даю свое согласие на использование файлов cookie. Это необходимо для нормального функционирования сайта, показа целевой рекламы и анализа трафика. Статистика использования сайта обрабатывается системой Яндекс.Метрика
Научный журнал Моделирование, оптимизация и информационные технологииThe scientific journal Modeling, Optimization and Information Technology
Online media
issn 2310-6018

Mathematical modeling of flexural vibrations of a rod with an intermediate perfectly rigid massive insert

idNusratullina L.R., Pavlov V.P. 

UDC 534.1+519.6
DOI: 10.26102/2310-6018/2026.61.10.022

  • Abstract
  • List of references
  • About authors

The paper considers a compound rod with an intermediate perfectly rigid insert of mass m and length s, which can be viewed as a simplified model of a gas turbine engine blade with a tip shroud. To calculate the bending vibration frequencies, the rod is divided into three coupled segments: two flexible segments and an intermediate perfectly rigid insert. Unlike traditional models that consider rods with point masses, this study takes into account the length of the rigid insert and its moment of inertia. This allows for a more accurate consideration of the influence of the translational and rotational motion of the rigid insert on the natural frequencies of the rod, which constitutes the scientific novelty of the study. In constructing the mathematical model, the continuity conditions for displacements and rotation angles of the rod's cross-sections are applied at the ends of the insert, along with the equilibrium conditions for the forces and moments acting on the insert. By applying the matching conditions and the boundary conditions at the ends of the flexible rod segments, a transcendental frequency equation is derived, the roots of which determine the natural frequency spectrum of the rod's free vibrations. Numerical analysis demonstrates that increasing the mass of the insert leads to a monotonic decrease in the natural frequencies, with the mass having the most significant effect on the lower natural frequencies. The model was verified by analyzing limiting cases (m → 0 and s → 0) and comparing the calculated results with known solutions for a homogeneous rod of constant cross-section. The calculation error for the natural frequencies does not exceed 1·10-4 %. The developed model is of practical value for the preliminary estimation of the natural frequencies of gas turbine engine blades with tip shrouds at the design stage, helping to prevent resonant operating conditions, which highlights the relevance of this study.

1. Vasilyev B.E., Magerramova L.A. Investigation of the shroud configuration influence of advanced turbine blades engines on strength characteristics. Vestnik USATU. 2015;19(3):28–32. (In Russ.).

2. Le T.D., Nesterenko V.G. Design methodology of the profiled part of the shrouded blades of the high-pressure turbine rotor of a gas turbine engine. Scientific and Technical Volga region Bulletin. 2017;(4):54–57. (In Russ.). https://doi.org/10.24153/2079-5920-2017-7-4-54-57

3. Belousov A.I., Nazdrachyov S.V. Defects of shrouded blade platforms of high-temperature gas turbines. Vestnik Samarskogo gosudarstvennogo aerokosmicheskogo universiteta im. akademika S.P. Koroleva. 2013;(3-2):15–21. (In Russ.).

4. Magerramova L.A. The structural variations of high-temperature turbine blades for increase of its design life. Vestnik USATU. 2015;19(2):79–86. (In Russ.).

5. Stupina N.N., Shorr B.F. Calculation of frequencies and vibration patterns of a disk with twisted blades connected by anti-vibration shelves. Problems of Durability. 1978;(12):102–106. (In Russ.).

6. Farafonov D.P., Bazyleva O.A., Rogalev A.M. Alloys for blade shroud hardening. Proceedings of VIAM. 2016;(9):07. (In Russ.). https://doi.org/10.18577/2307-6046-2016-0-9-7-7

7. Pavlov V.P., Nusratullin E.M., Nusratullina L.R. Investigation of the influence of the mass moment of inertia and the longitudinal force on the frequency spectrum of free transverse vibrations of the rod. Vestnik Bashkirskogo universiteta. 2024;29(2):62–68. (In Russ.). https://doi.org/10.33184/bulletin-bsu-2024.2.2

8. Nusratullin E.M., Nusratullina L.R. Numerical method for calculating eigenfrequencies of bending vibrations of a rod with an absolutely rigid intermediate insert. Vestnik Bashkirskogo universiteta. 2026;31(1):20–27. (In Russ.). https://doi.org/10.33184/bulletin-bsu-2026.1.3

9. Komarov O.A., Dmitriev S.Yu., Dautow D.R., Ossiala W.B.A. Efficiency losses in high pressure turbines with shrouding. Vestnik USATU. 2017;21(2):70–75. (In Russ.).

10. Belousov A.I., Nazdrachev S.V. Defining the field of existence of shrouded blades in high-speed gas turbines. Nasosy. Turbiny. Sistemy. 2020;(2):5–10. (In Russ.).

Nusratullina Liliya Rinatovna

Email: mardliliya@yandex.ru

ORCID | eLibrary |

Ufa University of Science and Technology

Ufa, Russian Federation

Pavlov Victor Pavlovich
Doctor of Engineering Sciences, Docent

eLibrary |

Ufa University of Science and Technology

Ufa, Russian Federation

Keywords: bending vibration frequencies, perfectly rigid insert, frequency equation, boundary conditions, matching conditions

For citation: Nusratullina L.R., Pavlov V.P. Mathematical modeling of flexural vibrations of a rod with an intermediate perfectly rigid massive insert. Modeling, Optimization and Information Technology. 2026;14(10). URL: https://moitvivt.ru/ru/journal/article?id=2553 DOI: 10.26102/2310-6018/2026.61.10.022 (In Russ).

© Nusratullina L.R., Pavlov V.P. Статья опубликована на условиях лицензии Creative Commons Attribution-NonCommercial 4.0 International (CC BY-NS 4.0)
21

Full text in PDF

Скачать JATS XML

Received 04.08.2026

Revised 12.10.2026

Accepted 19.10.2026

Published 31.10.2026